Seems the new sticks are slightly thinner, but comparing the original and new visually doesn't immediately suggest that. In the bottom slot, the original stick has a minimal snap, but the new stick has none. In the top, either original or new card kind of snaps in. It seemed that in the bottom slot, I don't get as much insertion resistance as in the top slot. I tried various combinations of reinsertion and also saw that either new stick in the bottom slot beeped. Either of the original sticks work in the bottom slot. Either of the new ones in the bottom slot (assuming this has been called slot 0) elicited the beeping sound every 3 seconds or so. I wanted to replace the 2 original 1GB Samsung sticks with 2GB sticks from OWC. Hope this helps cause it helped me tremendously after wanting to pull my hair out.Īn overall "me too". Its definitely a hardware issue and the seating of the memory in slot 0. Do the same procedure with the screwdriver and they both work again. When i take out the memory and put it back in normally i get the beeps again. I did this and tested out both sets of memory and now they both work. Take a small flat head screwdriver and after you put the memory in slot 0, put the screwdriver between the top of the mac mini and the memory then turn the screwdriver a little to exert pressure on the memory into the slot. What i did was what another thread advised to do. They both worked in slot 1 alone but nothing when in slot 0. I went through 2 brands of memory both had similar problems when seated into slot 0. Read on a thread it was how certain memory gets seated into slot 0 that causes it not to work. When i tried the old memory or just slot 1 then everything worked. It was always slot 0 that had issues of need reading the memory. I had the same problem as you on my mac mini.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |